Difference between revisions of "Temporarily Disabling and Re-enabling OnePager Pro"

Latest revision as of 17:47, 12 September 2016

Disabling OnePager Pro For Microsoft Project 2007 and Earlier

1) To disable OnePager so that it will not load when Microsoft Project launches and yet can be re-enabled when you choose, follow these steps:

a) Launch Microsoft Project 2007 or earlier (For Project 2010, 2013 and 2016, see alternative procedure below).

b) If the Microsoft Project Tools button on the menu bar does not contain the COM Add-Ins… command, do the following to add it:

i) Click the View button on the Microsoft Project menu bar then click the Toolbars button and then click the Customize Toolbars…. command to bring up the form below.

ii) Click the Commands tab of the form that appears.

iii) In the Categories: box on the left side of this form (shown below), select Tools.

iv) Scroll down on the right and find the COM Add-Ins… command. Drag this command and drop it into the highlighted Tools menu on the left.

c) Go to the Tools command and click the COM Add-Ins… command.

d) The COM Add-Ins form below will appear:

e) Uncheck the checkbox next to Chronicle Graphics OnePager and then click OK. The OnePager icon will go away and will remain absent whenever you launch Microsoft Project.

Re-Enable OnePager For Microsoft Project 2007 and Earlier

2) If you want to re-enable OnePager after temporarily disabling it, follow these steps:

a) Launch Microsoft Project 2007 or earlier.

b) Go to the Tools button and click on the Com Add-ins… command of Microsoft Project. (See Uninstalling OnePager Pro if you cannot find this menu command on the Tools menu.) The COM Add-Ins form shown above will appear.

c) Check the checkbox to the left of Chronicle Graphics OnePager and then click on the OK button.

d) The OnePager icon will re-appear and will now appear every time you launch Microsoft Project.

Disabling OnePager Pro For Microsoft Project 2010, 2013 and 2016

3) For versions of Microsoft Office© that employ the ribbon user interface (e.g. Microsoft Project 2010, 2013 and 2016), the procedure for temporarily disabling OnePager is different. Go to Microsoft Project menu bar File button and select the Options button as shown below:

a) This brings up the Microsoft-Office Project Options form. Click the Add-ins command as shown below:

b) This brings up the Add-ins form as is shown below:

c) At the bottom of this form, choose the Manage: COM Add-ins and press Go…:

d) This will bring up the familiar COM Add-ins form discussed above, where you can check or uncheck the OnePager checkbox:

Re-Enable OnePager For Microsoft Project 2010, 2013 and 2016

4) If you want to re-enable OnePager after temporarily disabling it, follow these steps:

a) Launch Microsoft Project 2010 or later.

b) Go to Microsoft Project menu bar File button and select the Options button as shown previously above. Then go to the Add-ins tab and click the Go… button associated with the Manage: COM Add-ins and the COM Add-Ins form shown above will appear.

c) Check the checkbox to the left of Chronicle Graphics OnePager and then click the OK button.

d) The OnePager icon will re-appear and will now appear every time you launch Microsoft Project.

(1.5)